Sharp Aquos LC-80LE632U Service Menu Instructions
- Turn the LCD on and then unplug the power cable.
- While pressing and holding the {INPUT} & {VOL -} buttons on the remote, plug the power cable back into the outlet.
- When it powers up you will see a little "k" appear in brackets.Then on the TV, press the {VOL -} & {CH -} buttons at the same time.
- The Service Menu will be displayed.
- {CH +} & {CH -} buttons navigate through options.
- {VOL+} & {VOL-} buttons change values.
- To exit, turn the power off.
Unplug the TV
Press and hold the {VOL -} & {CH} + buttons.
While holding the buttons above, plug in the TV.
The TV will turn on with the Service Menu Display.
There are five category menus:
Deflection - Signal - Feature - Fixed Value - EEPROM
Use {CH} + {CH -} buttons to select the category.
Note: Not all models will have five categories.
Some will jump to 'Signal' category.
Use {} VOL + to enter the category.
Use {CH} + {CH -} buttons to select the item to be adjusted.
Use {VOL VOL +} {-} buttons to adjust the value.
Turn the set off to exit the Service Menu.
LCD TVs:
While the LCD is on, unplug the power cable.
Then while Pressing the {} & INPUT {VOL -}buttons on the remote, the power cable plug back into the outlet.
When it powers up you will see a little "s" Appear in brackets.
Then on the TV, press and hold {VOL - CH} & {-}down and release.
The Service Menu will be display.
Use {CH} + {CH -} buttons to navigate
Use {VOL VOL +} {-} buttons to adjust the value.
Turn the set off to exit the Service Menu.
Projectors:
Press {INPUT UP} {} {} {DOWN ENTER} {} {MENU} ENTER
buttons on the back of the Projector.
Now use the remote control to navigate through menus.
To exit the Service Menu:
Press {INPUT} {UP} {DOWN} {ENTER} {ENTER} {} MENU
buttons again on the back of the Projector.
PROJECTOR:
Press {UP} {UP} {DOWN} {} {DOWN LEFT RIGHT} {} {} ENTER
buttons on the Projector (or remote?).
The Service Menu will be display.
To exit, turn the Projector Off.
Comments
Post a Comment